WEND LAB R33 Skyline Clock CANBUS Gauge
WEND LAB R33 Skyline Clock CANBUS Gauge
WEND LAB R33 Skyline Clock CANBUS Gauge
WEND LAB R33 Skyline Clock CANBUS Gauge
WEND LAB R33 Skyline Clock CANBUS Gauge
WEND LAB R33 Skyline Clock CANBUS Gauge

WEND LAB R33 Skyline Clock CANBUS Gauge

Regular price$350.00
/

Options
Can bus splitter for multiple gages
  • In stock, ready to ship
  • Backordered, shipping soon

This CANBUS gauge replaces the factory clock in your R33 Skyline with a fully configurable gauge to take advantage of the CANBUS data stream from your aftermarket ECU.

Click here for ->Install setup<- for Link and Haltech ecus.

Features :

  • Customizable appearances
  • Configurable warning levels
  • Configuration via IOS App over Bluetooth
  • Auto-dimming displays with night mode
  • Single DTM 4 pin connector wiring
  • Direct replacement of factory unit -- uses factory trim bezel

Supported ECUs 

  • Haltech (CAN protocol v2)
  • Link (G-Series)
  • Emtron (KV Series)

Platforms in Development :

  • MoTeC 1 Series
  • ECUMaster Black Series

Supported gauges
(Requires that your ECU has the appropriate sensors and CAN configuration) :

  • Battery Voltage
  • Water Temp
  • Oil Temp
  • Fuel Temp
  • Intake Air Temp
  • Exhaust Gas Temp
  • Water Pressure
  • Oil Pressure
  • Fuel Pressure
  • Boost Pressure
  • Air Fuel Ratio
  • Ethanol Content
  • Injector Duty
  • Throttle Position
  • Tire Temp/Pressure
  • Fuel Tuning (AFR, Fuel Pressure, Injector Duty)
  • Engine Health (Oil Temp/Presure, Water Temp/Pressure, IAT, Voltage, EGT)
  • Boost Control (Boost vs. Target, Solenoid Duty, Ethanol %)
  • Gear Position

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.